Kovac M., Vojtus J. Investigation of air flow in a twin roofs of residential houses.

UDC 536.2:620.9:502
M. Kovac, J. Vojtus
Technical University of Kosice, Slovakia
Civil Engineering faculty, Institute of Architectural Engineering

INVESTIGATION OF AIR FLOW IN A TWIN ROOFS
OF RESIDENTIAL HOUSES
© Kovac M., Vojtus J., 2017
Деякі види плоских дахів з малою висотою вентильованого повітряного прошарку мають певні проблеми з тепловологісним режимом. Нижчі температури поверхні внутрішніх конструкцій у повітряному прошарку даху та надходження нагрітого і вологого повітря з внутрішнього середовища будинку у повітряний прошарок призводять до конденсації водяної пари на холодних внутрішніх поверхнях конструкцій дахів. Такий вид плоских дахів використовували в нашій країні в кінці ХХ століття. Конструкцію плоского даху розділено на дві частини, між якими знаходиться вентильований повітряний прошарок завтовшки 150 мм. Багатошарова конструкція над повітряним прошарком захищає будівлю від дощу і снігу, а багатошарова конструкція під повітряним прошарком захищає будівлю від теплових втрат. Багато проблем виникало при прокладанні вентиляційних каналів або каналізації через таку конструкцію даху. Центральна система труб для вентиляції квартир (кухня, туалет і ванна кімната) про¬ходить через конструкцію даху, але повітропровід не пов'язаний безпосередньо з цен¬тральним вентилятором повітря на даху. Через конструкцію даху відбуваються витоки повітря. Такі місця є шляхом для природного руху теплого і вологого повітря з опалю¬вального приміщення в повітряному проміжку даху. Мета статті полягає в тому, щоб отримати відомості про швидкість руху повітря, внутрішні температури поверхні в повітряному прошарку існуючого плоского даху та потенційних місць конденсації вологи за допомогою CFD-аналізу. В дослідженнях було використано CFD інструмент ANSYS CFX.
Ключові слова: плоский дах, CFD, конденсація вологи.

Some kinds of flat roofs with low height of ventilated air gap have certain problems with thermal and moisture regime. The lower surface temperatures of internal constructions in the air gap of roof and presence of hot and moist air in the air gap from indoor environment of building causes condensation of water vapour at the cold surfaces of roof internal constructions. This kind of flat roofs was used in our country at the end of the 20th century. The used construction of flat roof is split in two parts. Between them is ventilated air gap. The thickness of the air gap is 150 mm. Multilayer construction over the air gap protects the building against rain and snow. Multilayer construction under the air gap protects the building against the thermal losses. Many problems were at that time with the quality of work, with realization of roof penetrations by building equipments such as ventilation duct or canalization. The central ductwork for ventilation of flats (kitchen, toilet, and bathroom) enters to the roof chamber but the ductwork is not directly connected with the central roof air fan. In the roof construction are many leakages. These places represent the path of natural motion of warm and humid air from heated space into the air gap of roof. The aim of this article is to gain the view on the air velocity, internal surface temperatures in the air gap of existing flat roof and potential places of air condensation by using CFD analysis. We used commonly used CFD tool ANSYS CFX.
Key words: flat roof, CFD, air condensation.

Кількість посилань 5